|
Article Groups
Service
|
|
Seal-contact-modules for high current transmission
Seal-contacts are constructed for high current transmission with
busbars and plates (copper/copper, Alu/copper or Alu/Alu) in indoor as
well as outdoor-installations. It is possible to connect unplated,
unmachined and uncleaned busbars or plates also in corrosive atmospheres
(e. g. sulphur dioxide, salt laden air, chlorine etc.). The modules are
suitable for bolted joints in busbars according to DIN. By using these
elements the high current transmission is made in hermetically sealed
chambers, so that no oxidation or corrosion is possible. So you get low
loss over a long time of use. The torsion spinglouver of the multilam
permits the contact force as well as the electrical performance of the
busbar joint to remain constant even when the compression force drops to
50 % of its initial value. The torsion spinglouver of the multilam get
through the oxydlayer of the busbar, so that a cleaning or coating of
the contact areas is not necessary. So screw connections with low loss
and without any servicing over a long time of use is guaranteed.
Part-No. |
technical data |
dimensions mm |
description |
length |
width |
thickness |
02696 |
contact module |
40 |
13,33 |
1,4 |
02697 |
support
modul long |
40 |
13,33 |
1,4 |
02698 |
support
modul short |
13,33 |
13,33 |
1,4 |
|
Remark: Continuous operating temperature up to +100° C, short circuit
current 1 s = 20 kA. |
|